How to Download and Install ArrowOS 11 on Redmi K20 Pro (Android 11)

ArrowOS is an AOSP based project started with the aim of keeping things simple, clean and neat. We added just the right and mostly used stuff that will be actually USEFUL at the end of the day, aiming to deliver smooth performance with better battery life. ArrowOS is a popular custom ROM and is supported by several devices across the globe. They are one of the most popular firmware distribution communities that give users to boost performance and deliver a stock Android. To we Guide “How to Download and Install ArrowOS 11 on Redmi K20 Pro (Android 11)”.

Today we are going to share a bit of knowledge to help with downloading and installing ArrowOS 11 on Redmi K20 Pro (Android 11) so far. In contrast, we have covered everything that you might require during installation with a proper guide so far.

About Redmi K20 Pro

It features to 6.39″ AMOLED Display with the 1080x2340px resolution. It has a 403ppi and 19.5.9 aspect ratio. This Device is Powered by a Qualcomm Snapdragon 855 Octa-core CPU with the Adreno 640 GPU. This Chipset, Coupled with up to 6/8GB of RAM and 128/256GB of Storage On-board. It runs the Android 9.0. This Device is Packed with a massive 4000mAh non-removable battery.

Pre-Requirements

• This is an Android 11 based ArrowOS, and it was supported for Redmi K20 Pro
• First thing first, you need to unlock your Redmi K20 Pro bootloader.
• Even you require TWRP Recover on your device.
• Need to download the required ArrowOS and TWRP Files.
• Not to mention, your device battery should charge above 60% for an interrupted process.
• Ensure that you have a complete backup of your data without root, so in case something went wrong, you have a complete backup to restore your device data.

Downloads

• Download ROM
• Download TWRP Recovery

How to Install TWRP Recovery

1. First, Download TWRP from the above link.
2. Next, Download and install ADB and fastboot on your PC
3. Switch Off your Smartphone
4. Open your smartphone on Fastboot mode.
5. Through power off your device and then hold the Volume Down + Power button
6. Now, Open the ADB folder on your PC and Laptop.
7. Press Shift+ Right Mouse Key and Click Command Prompt Here
8. Type the Command Prompt type the Command
   

   adb Reboot Bootloader

9. After That, Type Fastboot Devices

10. Now, Fastboot Flash Recovery “TWRP filename.img” and Hit Enter

11. Now”Fastboot reboot” and Hit Enter.

12. You have Successfully Install TWRP Recovery on Smartphone

How to Install ArrowOS 11 on Redmi K20 Pro

1. You need to Reboot your Device in TWRP Mode
   

   BOOT MODES Open Recovery Mode on Device First, power off your smartphone and then hold the Volume Down + Power button, then navigate using the volume button.

2. In TWRP Mode, click Wipe Data and tap Yes.
3. Boot again into TWRP Mode
4. Again tap Wipe>Advance Wipe, and Tap Select All Data Except SD Card and Swipe to Wipe
5. Now, Click Install and Flash ROM.zip on your Device.
6. After That, Restart your Smartphone.

Hopefully, we believe that you have been now successfully installed the PotatoOS based on Android 11 on your device so far. So you have Succesfully read About “How to Download and Install ArrowOS 11 on Redmi K20 Pro (Android 11)”. Moreover, you can also check out our website for more firmware on GearAllNews. Thanks for being with us. We would like to know your valuable opinion and feedback if there is any query share with us in the comment section down below.